I can’t imagine this is normal and the way it was when new. The sound quality is more better than usually on analog outs of ISA boards. Plugged it into an amplified speaker and with the volume up all the way I can just barely make out the music. I assume it’s a Soundblaster 16 clone anyway. Is anyone out there with some experiences or further information?
|Date Added:||25 June 2018|
|File Size:||36.16 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Guess worst case scenario I could always try sourcing an OPL3 chip and soldering it in place of the clone. Later I will tell more.
I can’t remember if I uploaded this before or if anyone has seen it but this is what my CT AWE32 replaced, came with the machine I bought: I’m not sure if I should buy it or not Can be amplified to make a good sound source. Did Mithloraite ever reach a verdict if the Yamaha on his board is genuine of a remarked one?
As regards the sound quality I checked the amplified Speaker Out yet, it’s no more noisy than Aztech’s and similar cards.
This disclaimer is brought to you thanks to the BSA. It doesn’t catch any noise from HDD reads like some Aztech cards unfortunately do it.
I can’t imagine this is logc and the way it was when new. Any suggestions on this board or should I throw it out and try again?
Do the OpAmps fail or could logci be something else? Used the mixer in dos and windows to turn it up but it’s about as good as a paper cup connected to a string. As it is now, it’s useless to pljs. I bought an ALS Plus and it’s pretty much the same.
Board index All times are UTC. It just used a pin connector instead of the standard pin. Despite having read this thread viewtopic.
If it weren’t for that, it would be a aavnce darn good SB16 clone. But it has a little relevance to current topic about SB16 clones. I don’t know why it would sound terrible on some speak but it does but I’m glad I kept it. It converts quickly and without las100, sound pitch doesn’t change.
Many thanks to gerwin! Is it worth going any further? Plugged it into an amplified speaker and with the volume up all the way I can just barely make out the music.
Diamond put a rebranded Avance Logic chip on their card. It plsu really awful with headphones plugged in and a set of speakers I had. They are definitely based on the same code, it is mostly the names that have been changed I assume it’s a Soundblaster 16 clone anyway.
Thus we get simple decision of sbpro compatibility issues on sb16 cards by using them separately.
Do you think that is great decision to make TTL signal? Out is 44,1 kHz always.
Would you be able to show us a photo? I am also using the CMI again, in my system. Tried some other speakers and it sounded reasonably good for a low end generic ISA sound card.