DIMENSION 4600C VIDEO DRIVER

Home  /   DIMENSION 4600C VIDEO DRIVER

Enter the system setup program and confirm that drive A or drive C is properly identified. Serial or parallel port test failure. An error occurred with the keyboard connector. Slave DMA register failure. Reinstall all memory modules and restart the computer. Timer-chip counter 2 failure.

Uploader: Kalkis
Date Added: 4 October 2008
File Size: 26.11 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44423
Price: Free* [*Free Regsitration Required]

This series of beeps, called a beep code, identifies a problem. This beep code tells you that dimeneion computer encountered a memory problem. The operating system cannot be located on drive A or drive C. If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts see “Resolving Software and Hardware Incompatibilities” in your Owner’s Manual.

Unexpected interrupt in protected mode. An error is occurring on the timer on the system board. Ensure that the floppy drive or the hard drive is installed correctly in the computer and defined correctly in the system setup program.

Timer-chip counter 2 failure. Determine if a conflict exists by removing vjdeo card not the video card and then restarting the computer.

If the computer starts normally, reinstall an additional module. If the problem persists, reinstall the card that you removed, remove a different card, and then restart the computer.

  HP 4430S BLUETOOTH DRIVER

Reinstall all memory modules and restart the computer. To eliminate the possibility of a faulty memory connector, remove all memory modulesreinstall one memory module if the computer supports a single moduleand then restart the computer.

Dell Dimension C Specs – CNET

If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts see “Resolving Software and Hardware Incompatibilities” in the Owner’s Manual. Slave DMA register failure. Before you begin any of the vvideo in this section, follow the safety instructions in your Owner’s Manual. Check the interface cable at both ends.

The keyboard or system board may need to be replaced.

If you have two or more memory modules installed, remove the modules, reinstall one moduleand then restart the computer. Reinstall all USB devices, check cable connections, and then restart the computer. If you have one memory module installed, reinstall it and restart the computer. One possible beep code code consists of one beep, a burst of three beeps, and then one beep. If you hear one of the following beep codes, see “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance.

If available, install properly working memory of the same type into your computer. Enter the system setup programverify the system configuration, and then restart the computer.

  MAC EPSON COLOR 900N DRIVER DOWNLOAD

After the computer starts, the lights remain green. Memory not being properly identified or used.

Advanced Troubleshooting

If the computer has a video card, remove the card and reinstall itand restart the computer. Interrupt vector loading failure.

The computer is in a normal operating condition after POST. Serial or parallel port test failure. Enter the system setup program and confirm that drive A or drive C is properly identified. Continue until you have identified a faulty module or reinstalled all modules without error. If the message you received is not listed in the table, see the documentation for either the operating system or the program that was running when the message appeared.

Memory modules are detected, but a memory failure has occurred. If the computer starts normally, move the memory module to a different connector and restart the computer. An error occurred with the keyboard connector.