Do not place jumper caps on the fan connectors! Insert the floppy disk with the original or updated BIOS file to the floppy disk drive. Optional documentation Your product package may include optional documentation, such as warranty flyers, that may have been added by your dealer. Copy the original or the latest motherboard BIOS file to the bootable floppy disk. The following figure shows a graphics card installed on the PCI Express xl 6 slot. Page of 75 Go. Boot Device Priority 2.
|Date Added:||17 January 2008|
|File Size:||55.49 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Secure the card to the chassis with the screw you removed earlier.
Hdd Smart Monitoring Capacity Displays the auto-detected hard disk capacity. Bios Setup BIOS setup program This motherboard supports a programmable firmware chip that you can update using the provided utility.
Connect one end of the chassis intrusion sensor or switch cable to this connector.
The system power LED lights up when you turn on the system power, and blinks when the system is in sleep mode. The Setup program is designed to make it as easy to use as possible.
After selecting this option, a confirmation appears. Where to find more information Refer to the following sources for additional information and for product and software updates. Select [System] to require the password before entering the system.
The product electricalelectronic audi, Mercury-containing button cell battery should not be placed in municipal waste. Page of 75 Go.
Installing A Dimm 1. Don’t show me this p5g-hvm again. Boot the system in DOS mode, then at the prompt type: Do not place jumper caps on the fan connectors!
This chapter also lists the hardware setup procedures that you have to perform when installing system components. Connect the optional USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis.
Place seven 8 screws into the holes indicated by circles asuz secure the motherboard to the chassis. The keys in the legend bar allow you to navigate through the various setup menus.
All specifications are subject to change without notice.
Even if you are not prompted to use the Setup program, you can change the configuration of your computer in the asu. Page 21 Remove the heatsink and fan assembly from the motherboard.
Page 4 Contents 2.
Pull up two fasteners at a time in a diagonal sequence to disengage the heatsink and fan assembly from the motherboard. Failure to do so may cause severe damage to audjo the motherboard and the components. This port connects the rear speakers on a 4-channel, 6-channel, or 8-channel audio configuration.
To print the manual completely, please, download p5y-tvm. When set to Last State, the system goes uadio either off or on state, whatever the system state was before the AC power loss. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
At the DOS prompt, type format A: System Memory Frequency Controls the system memory frequency. Turn on the system. Page 42 Chapter 1: The socket alignment key should fit into the CPU notch. If detected, the USB controller legacy mode is enabled.